I am remaking my Plasma Icicles this year. I am going with a higher density and all one length so I can do some different effect. They have been a hit every year since I introduced them.
deonb wrote:28 seconds into it
That look great! :thup:
What is the spacing between the drops and number of pixels per drop?
Not sure if you are looking for something like this?
https://www.wrightslights.info/assets/documents/The%20Making%20of%20RGB%20Dripping%20Icicles.pdf
I also saw a video or document where they used just the standard bullet nodes, with 5 going down in a line, then a piece of plastic tubing going horizontal to keep them separated at the bottom, then 5 back up in a repeating pattern. Not sure if it would be good for text though.
Edit: was actually this thread I was thinking of: http://doityourselfchristmas.com/forums/showthread.php?36910-Using-bullet-node-pixels-for-icicle-lights/page3
Generally speaking you want the vertical and horizontal spacing the same. And 8 pixels down is the minimum for letters. I started some with each drop being 15 pixels. Using 30/30 strips. There is a factory solder joint every 15 (1/2 meter) so it's just desolder the joint and it's already tinned for wiring. The actual spacing with nodes is up to you and the further away from the viewer the bigger spacing you can use. Strips you don't get a vertical adjustment and horizontal is up to you. The example above he started with wider spacing but moved them closer together for better readability.
Don Julian did a great job above. The was someone over at acl that used nodes and plastic fence to hold them.
