icicle replacement
 
Notifications
Clear all

icicle replacement

6 Posts
6 Users
0 Reactions
2,331 Views
Posts: 499
(@frederic)
Honorable Member
Joined: 14 years ago

Dangling Pixel Icicles, much like the icans:

And equal-length, pixel icicles:

You can make these yourself, whether they're IP68 string pixels you dangle at different lengths or strip pixels in plastic tubes with an end cap. They'd likely be wired so the top pixel receives serial data in, and the bottom pixel has wires going back up to the next icicle, feeding serial data in - so electronically, they're one continuous strand of pixels in serious, even though they're visually arranged as icicles.

I took a different approach, using very inexpensive chinese-made meteor lights. They typically come as a set of 8 or 10 and can be purchased in 20cm, 30cm, or 50cm lengths. I've only been buying the 50cm (20") ones that run on 12V. I remove the crummy wiring that's very short and replace them with a higher gauge, much longer wire, and add a short wrap around the top of the tube of solid wire with a hook, so I can hook them into tree branches easier using a pole while on the ground. Then I attempt to randomly connect the wiring to two different 27-channel DMX controllers (Holiday Coro has a great example of these, on sale too) and I drive them that way.

Each tube takes about 1.1 seconds to do it's cycle, so I turn on the channel, 10 tubes do their thing, and I shut off the channel. Spacing them all throughout a tree makes a nice effect and because it's above visitor's heads, it's kind of a "surprise".

Due to lack of time I didn't get them out this year, but I have about 500 of the tubes at this point. I buy them in sets of 8 or 10 depending on the eBay auction I buy them from that year, each tube cost me less than $3 with shipping. This year's batch cost me $23 for a set of 10 - that's $2.30 each!

Just an idea...


Reply
Page 2 / 2
Share: