I missing something
 
Notifications
Clear all

I missing something

23 Posts
5 Users
0 Reactions
6,142 Views
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

I just re-read your original post.
What happens when you put those snowflakes that only partially light on the other outputs? Does the symptom change?


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
Ruppro wrote:Port 3 should start at universe 12 channel 67 (like you started port 2 at 289). Also in Vixen you only have 132 channels assigned to Universe 13 and 288 assigned on the controller for port 4

Or for port 4 you would need to set it to universe 12 channel 356 (or whatever it port 2 ends at plus 1) which would roll over into universe 13 and 132 would be about correct in Vixen

That did it. By setting output 4 to 355 the end address is 132 and everything works. Thank you. Finally. 🙂

New setting

Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

Never fails. I get something to work, make a change and now I have an issue. I decided to use a 682 to run my snowflakes. I'm using 8 outputs, 1-1 to 2-4. Each output controls 48 pixels. The first 4 snowflakes work perfectly. However, 8 pixels don't' come on on snowflake #5. When I activate snowflakes #6, 8 pixels don't come on but the 8 pixels that didn't come on on #5 now come on. Activate snowflake #7 and 8 don't come on but the 8 that didn't come on on #6 are now on. Same thing happens when #8 is activated. This all happens using Vixen 3.
When I use the web setup for the 682 I turn off 2-1 to 2-4 and for 1-1 to 1-4 I enter outputs in use as 1. Only the first snowflake lights. I then enter 2 and the second snowflake lights. I continue this until all 8 are lit and everything works great.
Does this have something to do with the universe setup in Vixen? Right now I have the controller setup as Universe 11-510, Universe 12-510 and universe 13 as 132. I've changes numbers just to see what happens and things get really messed up. I've attached a pic of the web setup and the controller setup. Again, probably something really simple I'm missing.

192.168.1.213
Snow

Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

I don't think it is the solution, but is there a reason for the second group to start on 12-91 and not 12-67? (The difference here is 8 nodes.)


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

91 was set automatically by the webpage. Earlier changed it to 67 and hardly anything worked. After your reply I went down and changed it again. Now it works. I must have entered a wrong number the first time. Thank you.


Reply
Page 2 / 5
Share: