I missing something
 
Notifications
Clear all

I missing something

23 Posts
5 Users
0 Reactions
6,141 Views
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
[#42219]

Something I'm missing and for the life of me I can't figure it out. I'm running an E6804 that has 4 outputs. Originally I used one output to drive 384 pixels in groups of 96 (these are snowflakes) and used power injection. I decided to change and drive 96 pixels from each output. I can get the first 4 snowflakes (192 pixels) to work but then anything after that only partial snowflakes light up. I know it has something to do with the 6804 web setup but I can't seem to figure out what it is. Probably something stupidly simple. I have Vixen setup properly. I've attached the Vixen controller setup and also the 6804 web setup.

setup
Vixen controller

22 Replies
kkmm
Posts: 113
 kkmm
(@kkmm)
Estimable Member
Joined: 19 years ago

Mate you have an overlap on output 2 and 3
Output 2 is finishing on Universe 12 Channel 66
Output 3 is starting on Universe 12 Channel 1


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

well I see you have port 3 and 4 set at start ch 1


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

I know I have overlaps and ports set the same but I needed to start somewhere. I've made a ton of changes and still no go. We have storms coming into Kansas City and I need to get my car in. I'll have to continue this another time or even give Jim a call at Sandevices. Thanks for the input.


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

Port 3 should start at universe 12 channel 67 (like you started port 2 at 289). Also in Vixen you only have 132 channels assigned to Universe 13 and 288 assigned on the controller for port 4

Or for port 4 you would need to set it to universe 12 channel 356 (or whatever it port 2 ends at plus 1) which would roll over into universe 13 and 132 would be about correct in Vixen


Reply
Page 1 / 5
Share: