Help with BCR421U d...
 
Notifications
Clear all

Help with BCR421U datasheet

1 Posts
1 Users
0 Reactions
914 Views
jrock64
Posts: 1099
Topic starter
(@jrock64)
Noble Member
Joined: 19 years ago
[#48123]

Has anyone encountered or used this part before and could give some help on configuring it.

I found this part on mouser
https://www.mouser.com/productdetail/diodes-incorporated/bcr421uw6-7?qs=sGAEpiMZZMsE420DPIasPmbdCR5vW6EJrEvq01FjPd0uut3chMq2oA%3D%3D

That led to this datasheet
http://www.mouser.com/ds/2/115/BCR420UW6_BCR421UW6-553387.pdf

The key features being

LED Constant Current Regulator using NPN Emitter-Follower with Emitter Resistor to Current Limit
IOUT – 10mA ± 10% Constant Current (Preset)
IOUT up to 350mA Adjustable with an External Resistor (BCR421U)
VOUT – 40V Supply Voltage
PD up to 1W in SOT26 (SC74R)
Low-Side Control Enabling PWM Input < 25kHz (BCR421U)
Negative Temperature Coefficient (NTC) Reduces IOUT with Increasing Temperature

And most important, only 17 cents a unit at 100 quantities.

So my plan is to drive 4 RGBW stars at 350ma per channel.
16 channels of control provided by an ESP module and PIC16F722.

Now the 2 big questions.
If my input is 5v what is the valve of Rext to = 350 ma output and what power rating, I am looking at 0603 parts?
Example 7 on page 11 shows a 2.1 ohm resistor giving an output of 350ma.
But the supply is 12v, does this change because my supply is 5v.

Also they mention that En can accept PWM input.
is an additional resistor needed between the PIC high output and the En pin?

My plan is to cram all this onto a 2x3 in board.

Joel


Share: