Help Request: C9 LE...
 
Notifications
Clear all

Help Request: C9 LED string

1 Posts
1 Users
0 Reactions
845 Views
Posts: 1
Topic starter
(@andrewsan)
New Member
Joined: 11 years ago
[#49665]

Hello I'm a Newbie. I have an issue as described in the attached photo:

On part of my house outline, I have a single string of C9 "Brilliant Bulb" lights (purchased from HC). There's about 15ft of 14awg wiring before the 1st pixel. I first tested the string with an EasyPix controller by running through the embedded test sequences and all was fine even with all White LEDs. However, when I connected my Alphapix controller and run the similar embedded tests, the lights stop after the 6th node on the lower level of my house outline. A few of bulbs flicker after that sporadically.

I measured the voltage at the *end* of the string when the alphapix was connected, and it reads 11.8V (which I believe should still be enough voltage, correct?).

Can someone please advise what might be wrong?

thanks,
drew

drewLED help

Share: