Help / Recommendati...
 
Notifications
Clear all

Help / Recommendations

4 Posts
4 Users
0 Reactions
1,358 Views
Posts: 37
Topic starter
(@westcoastrednecks)
Trusted Member
Joined: 16 years ago
[#29919]

We are jumping into Pixels this year and we need some help deciding what will work best for us. I have drawn up a layout of our display and documented the distances to each of the elements. If y'all don't mind, could you give us some recommendations on what will work best for us as far as pixel voltages, controllers and controller placement. We already have a 6804 on order and would like to use the square pixels. Thanks!


3 Replies
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

Just a quick look at it and I would say 2 E6804 controllers. 1 in your tree and 1 beside your front door.Create 2 loops for your door/window pixels, 1 for the front door then loop to each of the 2 windows to the left. You may need to inject power I think at each window., then to the right go to the window then large door after as a single loop. The tree just use a controller on the tree itself.

I would use squares on your doors/windows but bullet style on your tree. Viewing angle on the bullets will be better than squares for your tree.

I prefer the 5V pixels myself, but either or will work fine. If you use 12V you might avoid having to do power injection on your doors/windows. The voltage is a debate always, with 12v you will get lower current through your extensions and so forth and probably reduce having to inject power that often.


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

Actually higher voltage does not change the current unless there is a switching DC-DC converter in the Pixel, something I'm looking into. The advantage is that you cal loose more voltage in the cable before it gets too low at the pixel.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago
timon wrote:Actually higher voltage does not change the current unless there is a switching DC-DC converter in the Pixel, something I'm looking into. The advantage is that you cal loose more voltage in the cable before it gets too low at the pixel.

I thought that some 12V strings/strips halved the current, presumably to reduce power dissipation in the pixels. Obviously this is not meant as a benefit, rather as something that is necessary for 12V operation in certain designs.


Reply
Share: