David talked several weeks about a version of the Falcon Pixelnet & DMX Dongle, FPD, which would stack with not only the Pi but also either Adafruit 2x16 display or my Display 4x20 display. David was kind enough to send me the schematics for the version 1.01 board so I relaid it out and the result was the FPD version 2.00.
The board layout is now complete and will go to fab shortly.
Here is the feature list.
- Uses the new PIC32MZ series processor which is considerably faster than the older PIC32MX used in version 1.0. (NEW 3/27/2014)
- Provision to install a PCF2129AT and Battery, same as used on the RASclock, so no external TOD clock is required. (NEW 3/27/2014)
- The processors on the FPD will have a boot loader so they can be programmed from the RaspberryPi. (NEW 3/27/2014)
- Board size is 93x115mm (about 3.65x4.53"). (UPDATED 3/27/2014)
- A cutout so you can still see the Pi's LEDs.
- Mounting hole pattern is on a 1"x1" grid so it will mount in either a CG500 or 1500 case. It will also fit in a CG-1000 case with three screws instead of four.
- It's a stacking system so the Pi can mount under the FPD and multiple display options can mount above it without using any ribbon cables. (UPDATED 3/27/2014)
- The board supplies power to the Pi through the P1 connector so you don't have to use a micro usb cable.
- There is a 1.1A polyfuse to protect the Pi as recommended by the RaspberryPi organization when powering through it's P1 connector.
- The Pi's serial port is brought out to a 3 pin connector.
- Provisions to connect a Battery Backed up supply so the Pi can safely shut down.
- There are provisions for a connector which allow access to the I2S and I2C ports so an external audio board or transmitter can be connected. (UPDATED 3/27/2014)
In addition I will be releasing three boards.
- The 4X20 display with the option for a optional PCF2129AT and Battery and the I2S and I2C ports for an external audio board or transmitter. (UPDATED 3/27/2014) Layout finished, waiting for FAB.
- A audio/RDS and FM02 control board which uses the I2S and I2C ports for much better audio than can be had with the Pi's standard audio. More information to come. (NEW 3/27/2014) Layout in process.
- A POE power supply with optional battery back and shutdown which can power the stack. Layout in process.
All of these will fit into a standard CNG500 case.
So below is the FPD board. You can see on the bottom side where the Pi mounts.

Updates:
- Optional power connector arrangements.
- Terminal Strip (TB1) or
- Any 0.1" spacing Right angle connector (P1). I suggest Molex C-Grid series.
- Barrel Connector for 5V only.
- Added second barrel connector on top side of board for 5V only.
Notched the PCB above the Pi's USB connector to allow for better access to it and to clear copper for WiFi module.
Rearranged 3.3V regulator for better heat dissipation.
Added the ability for optional heatsink if needed.
Added Falcon Logo.
Change RJ45 connectors to a tab up version for easier access.
Processor changed to PIC32MZ series
Added TOD Clock.
