Flickering window p...
 
Notifications
Clear all

Flickering window problem

11 Posts
7 Users
0 Reactions
2,548 Views
relic1882
Posts: 104
Topic starter
(@relic1882)
Estimable Member
Joined: 12 years ago
[#53208]

Hello all. It's been a while since I've been active but I'm glad to say I'm putting up the lights again this year. I had a question about some pixels being weird on me.

In the video you can see the left top window has a flickering/chasing thing going on at certain bright brightness levels. The top of the house has a lot of lights in one port on the controller so injecting power was necessary at the base of that window and on the right edge of the top. I had this problem a few years back and injecting power into the same spot fixed the issue. But it's doing it again and my connections seem ok.

Without injecting power the lights are haywire all over the second half of the run. It goes from controller->left edge-> roof peaks->right edge->bethlehem star->left window.

I'm trying to figure out what else I should be checking for. It seems unlikely to be any bad pixels as everything works when plugged in individually for testing before climbing up there.

Any insights? Thanks guys! The video is in the link below.

https://photos.app.goo.gl/18P6U76VCWquYGs7A


10 Replies
Wildbill
Posts: 259
(@wildbill)
Reputable Member
Joined: 16 years ago

Check the timing. Last year or the year before a new 2811 chip came out and that was the issue the timings were different. It was especially a problem with the E682 boards

Sent from my iPhone using Tapatalk


Reply
relic1882
Posts: 104
Topic starter
(@relic1882)
Estimable Member
Joined: 12 years ago

I'm using the same F16v2-R and 12mm bullets that I bought from Paul back in 2016. Nothing has been upgraded our updated since.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Almost seems like it's getting another signal from something else.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

looks like data corruption to me..
whether from wrong timing, noisy dataline or distance from controller is what you have to figure out..


Reply
Page 1 / 3
Share: