Flashing WS2811 Pix...
 
Notifications
Clear all

Flashing WS2811 Pixel

5 Posts
4 Users
0 Reactions
2,626 Views
Posts: 50
Topic starter
(@a2k97)
Trusted Member
Joined: 19 years ago
[#42563]

I think I've done about as much reading as I can on this site about others having issues with flashing pixels, and think I have come to the proper conclusion. I just want to run it by the experts before I start slicing and dicing.

I finally got my 450 pixel matrix setup and running properly on my E682 and through the FPP. I have 450 - 12V WS2811 square nodes, running on a 360watt power supply, with power injection every 100 pixels. I have the Dimmer on the E682 set to 50%, because at 100% there's lots of flashing. At 50%, however, everything seems to be running good, except for the very first pixel. It handles solid blue, red, and green just fine. But all white, yellow, or the FPP RGBW chase cause some flashing. The flashing is isolated to the first pixel only. I have skipped over the first 100 pixels and started at pixel 101 and everything seems just fine...no flashing. I have run just the first 100 pixels alone, and pixel #1 still flashes during the RGBW chase on FPP.

I have also tired making adjustments at the power supply by bringing the voltage down, which I have read eliminates the flicker for some. I even tried raising the voltage. I went through the entire range available and nothing changed.

So based on what I read, I think I have a bad pixel. Anyone else see a diagnosis or solution that perhaps I am missing before I go and cut out the problem and replace it?

Thanks.
Andy


4 Replies
Posts: 686
(@traneman)
Prominent Member
Joined: 16 years ago

A bad pixel would be my guess also.


Reply
Akentut
Posts: 235
(@akentut)
Reputable Member
Joined: 14 years ago

Don't know if this will help, but I have 5 E682's and was testing my lights for this year. I updated to the new beta firmware and had flashing on my 2811's and my pixel strips 2812Bs. The problem as I soon found out got fixed by changing the timing to 200 or 250 the flashing stopped. If you have the earlier firmware I'm not sure it had that option.


Reply
Posts: 50
Topic starter
(@a2k97)
Trusted Member
Joined: 19 years ago

Akentut,

That fixed the problem. Thank you. I do have 5.018 Beta and changed the timing to 200ms. It also worked with 250ms. No flashing of any kind, and I am able to run the dimmer at 100%. So even with all 450 pixels at full white there is no flickering.

Now if I could just get this one pesky pixel with the green LED that keeps going out to work properly. I think this one may require surgery.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

I had a bad pixel that would show blue. Just switched it out and good to go.

Sent from my SM-T710 using Tapatalk


Reply
Share: