Notifications
Clear all

F16v4 Test Mode

5 Posts
3 Users
0 Reactions
937 Views
Posts: 41
Topic starter
(@arl120384)
Trusted Member
Joined: 3 years ago
[#57151]

Evening All,

I finally have all of my outline pixels mounted but don't yet have any sequences created. I had to rent a JLG man lift to mount the lights due to the height of my house. I used Pixel Track for a permanent installation.

I am giving the man lift back before I'll have a sequence created and need to test the lights before I do, in case I need to tweak anything. I noticed theres a test button on my F16v4. Does this function test all the lights by chance? Or test something with the board?

Thanks!


4 Replies
tecnageek
Posts: 220
(@tecnageek)
Reputable Member
Joined: 10 years ago

The test button will test all channels from it's outputs.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Just connect the F16 to your network (or a computer to it) and access the UI. There are a few test options that you can turn on. If you can make the lights do things in response to UI control then you will be able to control them in a show.


Reply
Posts: 41
Topic starter
(@arl120384)
Trusted Member
Joined: 3 years ago

Awesome thank you!


Reply
Posts: 41
Topic starter
(@arl120384)
Trusted Member
Joined: 3 years ago

So I took someone else's advice and got a wifi extender and connected it to the F4. All the lights test perfect!

With one exception...

When I test one of my outputs, another set of strings on a different output has about 6 pixels that light up, and vice versa. Only with these 2 strings. Anyone seen this? The only thing I could imagine is some sort of crossed wire, but even that doesn't make any sense. Could it be a setting in the UI?

Edit: All fixed! It was an overlapping channel and I tweaked it in the settings!


Reply
Share: