F16V2 Virtual Strin...
 
Notifications
Clear all

F16V2 Virtual Strings - HELP!!

7 Posts
5 Users
0 Reactions
1,870 Views
Posts: 45
Topic starter
(@boknows)
Trusted Member
Joined: 11 years ago
[#43256]

I have configured one port with one Virtual String. I have 75 pixels of the WS2811 ribbon, which is BGR and then I have 98 pixels of your typical WS2811 square nodes. I have set up Port 3 (Wheel 4 and W4 Spokes) in the attached picture as such. Then I set up my controller to perform a green ramp and my results are not what I expected. The ribbon (75 pixels) is correct and the first 50 pixels of my square nodes are incorrect. Not sure how the remaining 48 pixels are correct. I have set up other exact models the same way and the outcome is the same. Maybe I am misunderstanding how to set up the Virtual Strings. Any help would be greatly appreciated. TYIA

CROSS POSTED - Falcon Christmas Forums

IMG 5227
ControllerSetup

6 Replies
Posts: 55
(@vavvoom)
Trusted Member
Joined: 10 years ago

Any chance the 98 squares are not the same, I'm going to assume this is 2 50 strings put together?

Idea: Break the 98 into 2 vert strings, make the first one 50 and leave RGB and then a new vert string of 48 and see if you can change to maybe BGR/BRG. Do you see where I'm going with this?


Reply
Posts: 55
(@vavvoom)
Trusted Member
Joined: 10 years ago

One more thing to check, is your ribbon WS2811 1 led per chip, the ones I have are cheaper and have 1 chip per 3 leds. Which in you case would make your 75 pixels map to position 225 of your controller ( I'm not talking about the Red/blue/green leds but a set.)

I don't think I was clear on what I'm trying to say. Hope you get it.


Reply
XmasInGalt
Posts: 526
(@xmasingalt)
Honorable Member
Joined: 19 years ago

I'm not sure if this is part of the issue but I see that you have a Zig count of 50 for all of your strings. If you don't intend to zig-zag your strings, then the Zig count s/b 0. You wouldn't see it for any strings <50 pixels.


Reply
Posts: 944
(@didjareally)
Noble Member
Joined: 12 years ago
BoKnows wrote:I have configured one port with one Virtual String. I have 75 pixels of the WS2811 ribbon, which is BGR and then I have 98 pixels of your typical WS2811 square nodes. I have set up Port 3 (Wheel 4 and W4 Spokes) in the attached picture as such. Then I set up my controller to perform a green ramp and my results are not what I expected. The ribbon (75 pixels) is correct and the first 50 pixels of my square nodes are incorrect. Not sure how the remaining 48 pixels are correct. I have set up other exact models the same way and the outcome is the same. Maybe I am misunderstanding how to set up the Virtual Strings. Any help would be greatly appreciated. TYIA

CROSS POSTED - Falcon Christmas Forums

You say your ribbons are BGR, but you have them set in the string ports as BRG, is that typo in your post?


Reply
Page 1 / 2
Share: