Notifications
Clear all

F-Amp Question

7 Posts
4 Users
0 Reactions
2,552 Views
Posts: 106
Topic starter
(@puppycrack)
Estimable Member
Joined: 6 years ago
[#53864]

This seems like a stupid question, but I can't seem to find the answer anywhere. Does an F-Amp need power (V+) to work properly? Or can I run only V- and data through it when doing power injection? I have some props that will be some distance from the controller, and am planning on locating power close to the props.

Thanks,
- pc


6 Replies
Posts: 344
 TSL
(@tsl)
Reputable Member
Joined: 10 years ago

How far from the controller? And yes it needs v+

Sent from my iPhone using Tapatalk


Reply
Posts: 106
Topic starter
(@puppycrack)
Estimable Member
Joined: 6 years ago

Thank you. I'm still in the planning stages, but could go as far as 40'. I have some diff receivers, but in one case, it would only be one string located a distance away, and it seemed a waste to have a diff receiver for only one string.

I suppose if I run V+ from controller, along w/ V- and data (in order to use the F-amp), I could still inject the prop as I was planning, with almost no V+ from the controller being used. Does that sound right?


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Yes the famp needs V+


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

You can run the V+ to the F-Amp and not bring it out.


Reply
Posts: 344
 TSL
(@tsl)
Reputable Member
Joined: 10 years ago
puppycrack wrote:Thank you. I'm still in the planning stages, but could go as far as 40'. I have some diff receivers, but in one case, it would only be one string located a distance away, and it seemed a waste to have a diff receiver for only one string.

I suppose if I run V+ from controller, along w/ V- and data (in order to use the F-amp), I could still inject the prop as I was planning, with almost no V+ from the controller being used. Does that sound right?

I know you can get 25’ from the controller to the 1st pixel. My longest run. Have you tried it to see if you need a f-amp? I use f-amps when I have a distance from pixel to pixel.

Sent from my iPhone using Tapatalk


Reply
Posts: 106
Topic starter
(@puppycrack)
Estimable Member
Joined: 6 years ago

Thank you all for the feedback - very much appreciated!


Reply
Share: