ESPixelStick Versio...
 
Notifications
Clear all

ESPixelStick Versions

17 Posts
8 Users
0 Reactions
4,394 Views
Posts: 3735
Topic starter
(@algerdes)
Famed Member
Joined: 15 years ago
[#52258]

A while back (2015?), I had a project that was supposed to be a bunch of props spread around a field. It was determined that they would work using some sort of wifi connected signal and local power supplies. So I purchased multiples of a new (at that time) device that sounded like it was perfect for the project. The project fell flat before the devices even arrived. So...

I have 15 or 16 of ESPixelStick version 1.1, dated 2015.08.18, just sitting on a shelf in the garage.

Another project has come to light, and I am thinking that I may be able to use the ESPixelSticks that were purchased 4+ years ago.

Before I get into it, I need to know - what is the newest version of firmware that will work with these sticks?

Where can I obtain firmware that will work on these sticks, with good installation instructions for the same. Remember, my motto is, "If it doesn't move - wire it!" My use of, and knowledge of using this type of device is "very limited". 🙁

Thanks for any and all information you can send my way.


16 Replies
Posts: 9
(@cschristmas)
Active Member
Joined: 9 years ago

Firmware can be found at github.com/forkineye

I believe the latest (3.0?) firmware should work on all the board revisions...

Sent from my SM-G975U using Tapatalk


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

How to >>

The latest version to download 3.1 >> https://github.com/forkineye/ESPixelStick

Hardware to load/flash/program the esp with new firmware >> http://www.renard-shop.com/accessories/64-renard-plus-esp-extreme-flasher-reefer.html


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

I believe it all depends on which ESP-01 you have. During the initial release of the v1 ESPixelStick, the ESP-01 was only 1/2m memory. Then old stock exhausted and the new 1m memory were shipped. With ESPixelStick v2 came the ESPFlashTool. The ESPPFlashTool requires the 1m memory. If you had the 1m memory the ESPFlashTool would work on v1, v2 or v3. ESP’s with 1/2m memory needed to stay with the old flash system, if you have the v1-1/2m ESP, upgrade your ESP-01 with a new 1m version (and not a PUYA memory chip) then you can use the current v3.1 https://github.com/forkineye/ESPixelStick/releases/tag/v3.1


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

At less than $1 USD a piece (delivered), it may be worth upgrading any 0.5M ESP01's to the latest production version.


Reply
Page 1 / 4
Share: