mrGrumpy wrote:..........(and not a PUYA memory chip)........
Others have reported that the new 3.1 firmware works with the PUYA chips.
3.1 works with the PUYA chipped ESPs I have.
Sent from my iPhone using Tapatalk
aclarksr wrote:3.1 works with the PUYA chipped ESPs I have.Sent from my iPhone using Tapatalk
Dirk stated the same, but later retracted. He said they programmed, but when he tried to set-up they failed to hold any program or changes.
https://diychristmas.org/vb1/showthread.php?10336-ESPixelStick-Travis-Builds-and-PUYA-memory-issue&p=110521&viewfull=1#post11052 1"> https://diychristmas.org/vb1/showthread.php?10336-ESPixelStick-Travis-Builds-and-PUYA-memory-issue&p=110521&viewfull=1#post110521https://diychristmas.org/vb1/showthread.php?10336-ESPixelStick-Travis-Builds-and-PUYA-memory-issue&p=110521&viewfull=1#post110521
Puya works fine . I have 1 loaded as typing this . No issues at all saving settings & rebooting to saved .
I did use two of the Puya chipped ESPs with a PixelPopTiny to test an order of 2000 WS2811 bullet nodes last weekend. I flashed them on my home network then using the web interface change settings to my show network without any issues. These are ESPs I bought over two years ago. They were only used for a short while to test new pixels though. I’ll have to break them out and test further.
Sent from my iPad using Tapatalk
