EspixelStick v4.X I...
 
Notifications
Clear all

EspixelStick v4.X Install Problem

67 Posts
6 Users
0 Reactions
12.1 K Views
Posts: 49
Topic starter
(@gatoruss)
Trusted Member
Joined: 5 years ago

I had ordered a MELIFE ESP32-DevKitC core Board for ESP32 Development Board ESP32-WROOM-32U from Amazon and it just arrived. This device comes with an external antenna enabled and there is not need to move a microscopic 0 ohm resistor.

I successfully installed the firmware from the google drive -- using D1 DevKitC as hardware. It installed fast, but after the install the serial monitor froze while the device booted up (log attached). However, when I logged onto my router I saw that the device was connected with an IP address. I was able to access via the webpage.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
gatoruss wrote:I had ordered a MELIFE ESP32-DevKitC core Board for ESP32 Development Board ESP32-WROOM-32U from Amazon and it just arrived. This device comes with an external antenna enabled and there is not need to move a microscopic 0 ohm resistor.

I successfully installed the firmware from the google drive -- using D1 DevKitC as hardware. It installed fast, but after the install the serial monitor froze while the device booted up (log attached). However, when I logged onto my router I saw that the device was connected with an IP address. I was able to access via the webpage.

Did you get the 5g antenna ?


Reply
Posts: 49
Topic starter
(@gatoruss)
Trusted Member
Joined: 5 years ago
angus40 wrote:Did you get the 5g antenna ?

I already had dual band.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

New version has been uploaded to the google drive. I turned off Relay support on the ESP8266 builds. It was causing the startup to fail. Not sure why but this is a workaround to getting people moving. Tested the flash tool on my D1Mini and it works properly for this version.

https://drive.google.com/file/d/1DG3wz8lbYNc371OIbeOqkzMaY5Zd2SKA/view?usp=sharing

Martin


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Curious .
What is the issue with the v4.04.zip other than it being older from the release page that requires this ?


Reply
Page 6 / 14
Share: