ESPixelstick Pixel ...
 
Notifications
Clear all

ESPixelstick Pixel driver / Xlights setup

19 Posts
6 Users
0 Reactions
13.6 K Views
T.D.Sutton
Posts: 445
Topic starter
(@t-d-sutton)
Honorable Member
Joined: 17 years ago
[#46844]

I powered up my Mega tree tonight, first time 🙂 21 strands of 75 x 5 volt pixels, driven by 7 ESPixelsticks, three strands per Pixel-stick, on test run using the test tab on the web interface brilliant, thanks to Shelby 🙂 The 200 amp 5 volt supplies working fine 🙂

Big problem though, when I ran a sequence/test from Xlights, the output to each pixel stick appears to be truncated at the universe barrier, ie 75 Pixels per string x 3 = 225 pixels, or 675 channels, it happily runs up to 510 channels but ignores the last 165 channels putting garbage on the rest of the string. I realise this will be a setup mistake on my behalf, but as a relative newbie to Xlights I cannot see how to make the setup address more than 510 channels per output. I though I had it correct but now I am not so sure!! More often then not I suspect it will be a terminology comprehension problem trying to read between the lines 🙁

Attached are the setup pages ex Xlights, sorry about the screen grabs!:-

Xlights Setup Page 2
Xlights Mega Tree setup

Any thoughts gratefully accepted

Terry


18 Replies
Posts: 2229
(@plasmadrive)
Famed Member
Joined: 15 years ago

I am by no means versed well in xlights these days, but I find that if I have any single universes with less than 510 as the channel count, it make the test patterns look funky. Perhaps that may make a difference for you, perhaps not. Try changing to 510 ch on those universes you have listed as 165.


Reply
DrNeutron
Posts: 2016
(@drneutron)
Noble Member
Joined: 14 years ago

I am at work ATM, but when I setup my ESPIXELSTICK last year (ran 429 pixels off one stick).
The stick used all 512 channels, and I believe I set each up as a single output.
When I get home I'll post a pic of my Xlights layout.


Reply
sporadic
Posts: 1199
(@sporadic)
Noble Member
Joined: 14 years ago

By default, the ESPixelStick has a universe boundary of 512 and your xLights configuration is using 510. If you're not on 3.0-rc3, you need to upgrade to that first and then you can change your universe boundary to 510 in the ESPixelStick configuration page.


Reply
T.D.Sutton
Posts: 445
Topic starter
(@t-d-sutton)
Honorable Member
Joined: 17 years ago
sporadic wrote:By default, the ESPixelStick has a universe boundary of 512 and your xLights configuration is using 510. If you're not on 3.0-rc3, you need to upgrade to that first and then you can change your universe boundary to 510 in the ESPixelStick configuration page.

Thanks Shelby, All 7 ESPixelsticks are on 3.0-rc3, and set for 510 Channel boundary's, I also have "told" the ESPixelsticks that they are each driving 225 Pixels, that made a difference to look of the built-in test program on the strings 🙂

Terry


Reply
Page 1 / 4
Share: