ESPixelStick Flash ...
 
Notifications
Clear all

ESPixelStick Flash Tool

223 Posts
49 Users
0 Reactions
100.3 K Views
Posts: 19
(@lewdi)
Eminent Member
Joined: 16 years ago

Not sure if I am doing something wrong, but I can't get it to output to my Renard. I have flashed the serial version using the new web flash tool and set it up to use the renard protocol. I only have 2 connections Data and Ground connected. I am using 2.0 of the firmware. Should I try a different firmware to validate? I also tested the same unit set up to drive pixels, and it worked great.


Reply
Posts: 116
(@coaster)
Estimable Member
Joined: 15 years ago
sporadic wrote:Updated flash tool along with the v2.0 firmware is here. Linux stuff should be fixed, but was unable to test on Mac. Used a Lubuntu 16.04 VM for testing.

Can confirm that it works with a Mac with CP2102 usb adaptor


Reply
sporadic
Posts: 1199
Topic starter
(@sporadic)
Noble Member
Joined: 14 years ago
mrGrumpy wrote:Works Great. Easy fix/addition. and an expedited answer....you keep amazing me!

Good to hear, thanks! You caught me between work and taking the kids to soccer practice 🙂

lewdi wrote:Not sure if I am doing something wrong, but I can't get it to output to my Renard. I have flashed the serial version using the new web flash tool and set it up to use the renard protocol. I only have 2 connections Data and Ground connected. I am using 2.0 of the firmware. Should I try a different firmware to validate? I also tested the same unit set up to drive pixels, and it worked great.

How are you making the connections to your Renard controller? Baud rate correct I assume?

Coaster wrote:Can confirm that it works with a Mac with CP2102 usb adaptor

Sweet, thanks!!


Reply
Posts: 19
(@lewdi)
Eminent Member
Joined: 16 years ago
sporadic wrote:
How are you making the connections to your Renard controller? Baud rate correct I assume?

I checked the baud rate and it is set correctly. even checked my cable with the old Renard setup and it was good. Any other ideas?

SerialPortConfig

connections

Reply
sporadic
Posts: 1199
Topic starter
(@sporadic)
Noble Member
Joined: 14 years ago
lewdi wrote:I checked the baud rate and it is set correctly. even checked my cable with the old Renard setup and it was good. Any other ideas?

How is it connected on the Renard side?


Reply
Page 8 / 45
Share: