ESPixelPOPs Build & Setup Guides
Hi All,
I am running a workshop on Pixels and E1.31 control at my local MakeSpace and have included a kit to make a ESPixelPOPs controller. Since some of the participants have little electronics building experience I made up a reasonably detailed guide to put one together.
Then I figured I could use most of the same content to make a generic build guide that might be of help to others....
Then I played with making a DMX output version and figured I may as well make up a guide for it also...
So if you go to: http://zappedmyself.com/projects/espixelpops/ you will find PDFs of both at the top of the page...
I'm sure there are typos and mistakes...
I am not a webmaster nor a technical writer (I'm sure that will be quickly apparent)...
YMMV....
Super Nicely Done Writeup.
Especially the DMX portion which has not been well documented before.
Thanks...
For anyone interested I just updated them with page breaks to keep the relevant instructions aligned with the matching picture..
And made a few tweaks...
Re: ESPixelPOPs Build & Setup Guides
Very well laid out , only question I have is on the DMX side, what application would the dmx version be used for ?
Thanks
Sent from my iPhone using Tapatalk
The DMX version has so many applications. There are a LOT of devices out there that use DMX as their method to talk. I have a trailer full of lights and what would be considered props in this hobby, all controlled by DMX. I have several "wireless" connectors. I guarantee you that the cost of the wireless version presented here is much cheaper than the ones I use on a regular basis.
Besides - If you think about it, we all use DMX. E1.31 is "DMX over Ethernet".
I have linked to your Blog from the PixelPops Wiki.
Again, thanks for constructing these. They will be a great resource going forward.
algerdes wrote:The DMX version has so many applications. There are a LOT of devices out there that use DMX as their method to talk. I have a trailer full of lights and what would be considered props in this hobby, all controlled by DMX. I have several "wireless" connectors. I guarantee you that the cost of the wireless version presented here is much cheaper than the ones I use on a regular basis.Besides - If you think about it, we all use DMX. E1.31 is "DMX over Ethernet".
I have added a new guide for installing WLED on your ESPixelPOP. I wouldn't use it for streaming E1.31 (though it can do that) but it does give you a wide variety of canned lighting effects and sequences to play with. And it will run on your ESPixelPOP. You may find it handy for a simple lighting project where you don't want to involve streaming E1.31 from Xlights or Vixen.
You will find all three guides (ESPixelPOPs, ESPixelPOPs DMX and ESPixelPOPs WLED) here: http://zappedmyself.com/projects/espixelpops/
packetbob wrote:I have added a new guide for installing WLED on your ESPixelPOP. I wouldn't use it for streaming E1.31 (though it can do that) but it does give you a wide variety of canned lighting effects and sequences to play with. And it will run on your ESPixelPOP. You may find it handy for a simple lighting project where you don't want to involve streaming E1.31 from Xlights or Vixen
Thanks I was thinking of doing a lighting project for my cabinets on my 3-d printers using the pixel pops . I’ll have to check it out .
Sent from my iPhone using Tapatalk
