ESPixel GECE Info T...
 
Notifications
Clear all

ESPixel GECE Info Thread

123 Posts
28 Users
0 Reactions
51.4 K Views
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

I've got 25ct, 35ct, 50ct, icicles, itwinkle, g90, g60 and they all have the same control box. So even though the boards inside the box's are different, these will work with all of them.


Reply
Posts: 339
(@heldwhat-christmas)
Reputable Member
Joined: 15 years ago
AuburnLights wrote:You're right on the money. Totally depends on the AP you're going to use. A lot of us that use them use Ubiquiti equipment for our show network which has a much better range, but it's not omni-directional so you have to be careful where and how you place the APs so that your elements will receive a signal.

Any recommendation on what Ubiquiti equipment? Just the $64 access point on Amazon or more than that?


Reply
AuburnLights
Posts: 213
(@auburnlights)
Estimable Member
Joined: 12 years ago
Heldwhat Christmas wrote:Any recommendation on what Ubiquiti equipment? Just the $64 access point on Amazon or more than that?

From what I have seen most are running the NanoStation locoM2 or the NanoStation M2. I believe the PicoStationM2 would work, but I don't have any experience with that so don't quote me on that. Do not select any M5 product as the ESP8266 modules only support 2.4 Ghz, not 5 Ghz, at least at this time. Most people think that 5 Ghz will not be supported as it requires a much higher power draw to support the data throughput. Also the M9 (900 Mhz), M3 (3 Ghz) or M365 (3.65 Ghz) products will not work with these modules.

Important: These products are directional and not omni-directional so you have to make sure and aim them correctly so all of your ESP8266 Modules receive a signal. This is different from most APs so I'm repeating myself for clarity. According to the Spec sheet they have a beam width of 60 degrees and a beam height of 60 degrees.

NanoStation Data Sheet

PicoStation Data Sheet


Reply
Posts: 7
(@jonchilds)
Active Member
Joined: 15 years ago

Just ordered some from the GB. These seem pretty cool.

Does anyone know how many pixels will be supported on one controller? I would like to keep the standard power supply, but splice a couple of my 25 bulb sets together so I could cut down on the number of controllers I would need.

Thanks
Jon


Reply
AuburnLights
Posts: 213
(@auburnlights)
Estimable Member
Joined: 12 years ago
jonchilds wrote:Just ordered some from the GB. These seem pretty cool.

Does anyone know how many pixels will be supported on one controller? I would like to keep the standard power supply, but splice a couple of my 25 bulb sets together so I could cut down on the number of controllers I would need.

Thanks
Jon

If you are using GECEs, the maximum is 63 in a string. It's not a limit of the board or code but rather of the GECE protocol that only has enough addressing for 63 Pixels plus and ending address. Some people say 64 Pixels max, I have had issues if I try 64 instead of 63. I don't know about others. Also, keep in mind that your 25 ct GECE power supply is smaller (less amperage) than the power supply provided with the 50 ct, so you may have to use a different power supply.


Reply
Page 14 / 25
Share: