I know it isn't in the 100 piece set (I have it). I just use a small slotted screw driver
I have the smaller set and it's not there. I took a square bit and filed it down to size.
jklingert wrote:Has anyone found the correct screwdriver to take out the triangle shaped screws?
One of the 4 (they aren't individually marked as far as I can tell) in this package works perfectly. I even used a 1/4 drive socket on the top of them to help break the epoxy seal on the screws. Worked great, not a single stripped screw.
Here's the Link (Edit also here)
I have GECE Icicles (20 per unit) older style (3 boxes). Would this controller work? And if it does, I suspect it would need a different case, right?
The box look likes this one: http://www.ebay.com/itm//141853427391 and the controller is white with a single button to change effects.
jklingert wrote:Any thoughts about waterproofing these? The original GECE controller had some sort of epoxy poured into the wire end in the trapezoid shaped cavity to stop water ingress along the wires. Has anyone found the correct screwdriver to take out the triangle shaped screws?
I bought a small precision screwdriver set off Amazon for $10 and it has a triangle tip that fits into these screws perfectly. Here's a link: http://www.amazon.com/Professional-Portable-Screwdriver-Extension-Maintenance/dp/B00FO18LZQ/ref=sr_1_2?s=hi&ie=UTF8&qid=1451878165&sr=1-2&keywords=jackly+precision+screwdriver If you mouse over the picture to enlarge it, the triangle tip is in the bottom row, left side of the tips.
As for waterproofing, I just used some outdoor-rated silicone I bought in a tube from Home Depot - I think it was less than $5.
