ESP modules that I...
 
Notifications
Clear all

ESP modules that I got recently

7 Posts
4 Users
0 Reactions
1,984 Views
Posts: 9
(@thomashp)
Active Member
Joined: 8 years ago

You can run the Renard board with the ESPixelStick V3.0 firmware you just need to select seril output instead of pixel output.

Capture

You can also wire them to the board using your Pixel stick with some jumper wires by removing the U1 chip and wiring data to pin 1, ground to pin 5 and Vcc 5v to pin 8. Your pixel stick would need to be setup for 5v operation to do this.


Reply
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago
Reply
Page 2 / 2
Share: