Notifications
Clear all

E682 Zig Zag

10 Posts
3 Users
0 Reactions
5,819 Views
Posts: 357
Guest
Topic starter
(@jerry72)
Reputable Member
Joined: 13 years ago
[#46325]

I am trying to set up my controller for my matrix. I am not understanding the Zig Zag set up. my matrix is 24x50, for outputs 1-4 i will have 100 pixels, same for outputs 9-12. When setting the zigzag, it asks for starting zigzag, then zigzag every. What do i put in these lines.?


9 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Do your 100 count strings/strips have zigzag configurations ?

If no , you need not use this feature .


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

If you have 100 count string, 50 up and 50 down then that is the number you enter.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Reputable Member
Joined: 13 years ago

The 100 count string will run through 2 lines of the matrix, say line 1 will be channels 1-150, line 2, would be 151-300, this would be the second set of 50 nodes, so i want to say first zig at 50, then zag every 50 after that. But i do not want to use reverse, correct?


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

No reverse. On zigzag pixel 100 will be pixel 51. Pixel 99 will be Pixel 52, etc.

Sent from my SM-T710 using Tapatalk


Reply
Page 1 / 2
Share: