pmiller wrote:You can also change the network resistors on the 682 for longer runs. Also, the 6804 uses 5-12 volts and the 682 uses 5-24 volts. Both will power 2040 pixels total using unicast and 1,190 pixels multicast. The 682 can also be powered by 2 different power supplies which will allow you to control 5 and 12 volt pixels at the same time.Sent from my SM-T710 using Tapatalk
+1
Plus, each of the four banks on the e682 can be configured for different type pixels, and, each of the ports can be configured for a specific number of pixels (back some time ago, each of the four ports on a bank were configured for the same number of pixels).
If you can put one together yourself, I would go with the e682. I run three of them in my show.
Keith R wrote:+1
Plus, each of the four banks on the e682 can be configured for different type pixels, and, each of the ports can be configured for a specific number of pixels (back some time ago, each of the four ports on a bank were configured for the same number of pixels).
If you can put one together yourself, I would go with the e682. I run three of them in my show.
Yea I think I will start with e682 , still more reading and learning todo for all the set up yet ... thank you !
Sent from my iPhone using Tapatalk
Would like to find out if I can ADD this type controller w/pixels to my existing ac led string light 96 channel set up or would it all need to be just pixels w all same controllers . Using vixen3with2 arduino mega 2560 currently with the sainsmart ssr
Sent from my iPhone using Tapatalk
I can't answer about the arduino but I don't see why not. I have 3 E682's myself. Got 1 the first year and and 2 more the next year (kits). I use Renard Plus to run my ac lights and they start off of my last E682. You can set a group up to run Renard or DMX. I love mine and built them all myself.
Sent from my SM-G900V using Tapatalk
wilmar wrote:Would like to find out if I can ADD this type controller w/pixels to my existing ac led string light 96 channel set up or would it all need to be just pixels w all same controllers . Using vixen3with2 arduino mega 2560 currently with the sainsmart ssrSent from my iPhone using Tapatalk
Sure no problems doing that, just add a E1.31 controller to your current display setup in Vixen3 for the E682
