E682 some lights fr...
 
Notifications
Clear all

E682 some lights freezing

13 Posts
5 Users
0 Reactions
3,654 Views
Posts: 91
Topic starter
(@franchise)
Estimable Member
Joined: 19 years ago
[#57196]

Sorry to bother everybody. I have an E682 being controlled by FPP and a couple random strands of lights will be fine but then will freeze on a color at some point in the show.

A little more detail. I have been using this E682 for 10+ years. For most of those years, it was controlling 400 lights without any problems. Last year I did 1000 lights with it without any problem. This year I am using 1600 lights. My EE buddy said it was a voltage problem which makes sense. I was turning the lights to yellow and getting 12 strands to freeze all the time. Switching to red and now occasionally 1,2, or 3 strands will freeze. Is there anything I can do?


12 Replies
Aurbo99
Posts: 2804
(@aurbo99)
Famed Member
Joined: 19 years ago

What voltage are you using?

How many power supplies are you using on the e682?


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

Also screenshots of your E682 configuration could be useful.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

This does sound like you need to have power injection and you need to ensure the PSU is not sagging. I used to have a similar issue anytime I set all my pixels to white. A whole lot of the strands would simply stay white. Turns out the PSU was getting old and when I tried to draw that much power, the PSU voltage dropped to a level too low to allow the pixels to recognize new data from the controller. This can also happen on long wire runs and (for me) on fast transitions to white that lasted too long for the Voltage to recover.


Reply
Posts: 91
Topic starter
(@franchise)
Estimable Member
Joined: 19 years ago

Thank you so much for all of the replies. I am using the E682 in PS1 configuration where there is one 350W power supply. Jim from Sandevices replied to my email that it is most likely a power issue.

What can I do about it in the short term? I assume red, blue or green draw less power than some color that uses all the of them. Is there any particular color that draws the least power? Can I set something in Xlights so that it slowly ramps up to that color? Would that help?


Reply
Page 1 / 3
Share: