this is referencing e682 pixel control board.
the board is totally inaccessible.
all the lights stay steady. pressing the restart and prog button causes the red/grn led to go off.. after 2 blinks i release the PROG button.
this should put the board into default IP settings.. 192.168.1.106 and 169.254.74.73 to connect directly via Ethernet to the e682.
using both ip's there is no access...
i have contacted Jim, and he agrees there is something amiss.
What firmware version is the board at?
The first time accessing my boards, I had to ensure the ethernet controller to the WAN (internet router) was disabled or at the very least disconnected from the 'net
I'm using two separate ethernet controller cards on my system.
Aurbo99 wrote:The first time accessing my boards, I had to ensure the ethernet controller to the WAN (internet router) was disabled or at the very least disconnected from the 'net
Same here.
Is your computer connected to a wifi network? If yes, be sure to disable the wifi on your computer, restart the computer, then try to connect to the controller.
See my last email. I'm thinking you're running version 4 and the over-rides are different. Override 6 will force an address of 192.168.1.206. Override 1 will display the board's current IP address on the LEDs.
