E682 one wonky outp...
 
Notifications
Clear all

E682 one wonky output

4 Posts
2 Users
0 Reactions
1,258 Views
Posts: 25
Topic starter
(@trooper)
Eminent Member
Joined: 15 years ago
[#39740]

Hello all-

I have a 682 that works fine except for one output, 3-2 only puts out a jumble of random pixels when I run the system test. Red, Blue or green its just a jumble. I have tried various strings to see if that was the issue, but alas it was not

Andy


3 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

First try swapping around/reseat the resistor pack for that connector, then try swapping the chip next to it (buffer chip) with another block to see if it moves.


Reply
Posts: 25
Topic starter
(@trooper)
Eminent Member
Joined: 15 years ago

Replaced it with a new one, problem still there


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Well - - assuming things are configured correctly and you're sure it's the hardware, then there is not a lot else there for a single port failure. You can try reflowing the chips/sockets for those blocks and see if that helps but next would be a swap of the Propeller chip with another if you have one.

It's basically Prop->Buffer Chip->R-pack->Connector...

The smaller chip inside the buffer chip is used to select either the clock signal or invert the data signal for balanced outputs so that would not be a likely candidate - but worth a shot I guess...


Reply
Share: