New to the pixels and this will be my first year implementing them. Using Vixen, and was wondering if I can use the LOR board to run Rgb floods, and my Sandevices to run my pixels? What the best method to run flood lights?
Thanks
Kevin
Sent from my iPad using Tapatalk
I know nothing about flood lights but certainly the E682 and E6804 are pixel controllers. I do not know what Vixen outputs; if E1.31 you are good to go.
The LOR cmb24d can be run in dmx mode so just conect it to your E682's dmx out, I don't think the E6804 has a dmx out on it.
If you still want a 4 port controller that can output dmx look at the pixlite 4.
If you are running vixen 3 you can use E131 so your pixel controllers will run fine, and if you are running vixen 2 or 2.5 I think there is a E131 plugin somewhere for that but sequencing pixels in that would be a pain.
Also if you are interested in other dumb rgb controllers I like these 30 channel dmx controllers you can get from ebay: http://www.ebay.com/itm/30CHANNEL-27CH-EASY-DMX-LED-controller-DMX-decoder-driver-RGB-led-controller-/261954571788?hash=item3cfdb58e0c:g:8jMAAOSwA4dWMdRZ
Hope this helps!
Thanks for the info, that helps.
Sent from my iPhone using Tapatalk
You can run your LOR cmb24 controller from both the 682 and 6804. If you use a 682 you would take up all 4 ports on one bank if running in DMX, 1-1 through 1-4 for example. I use a section of cat5 to connect one end to the 682 euro connector and the other end to a keystone Jack. Then just run a regular ol cat5 cable to my cmd24d controller. There's a few more fine details but that's the rough overview.
http://sandevices.com/documents/SanDevices_E6804_Pixel_Controller_Operating_Manual.pdf
It states "4 connectors for pixel strings, DMX, or Renard." (page 2 - Specifications)
Excellent, thanks everyone. I found John Storms video on this exact topic so now I think I'm good to go! .... For now. Haha
Sent from my iPad using Tapatalk
