Hello Trying to get set up and having one last issue. I have an E682 controller and am having issues with connecting to it. I can plug it in to the router and connect to it fine and adjust the settings. However when I connect it to my rasp pi setup (3b+ running FPP v4.5) I cannot connect to it anymore. Further I tried connecting to my laptop directly via ethernet and in order to connect first I have to turn off wifi. Secondly once it does connect it lasts for maybe 15-20 seconds then goes to unavailable for about 30 seconds then after refreshing will show just long enough to adjust one output if I am lucky before disconnecting again. This goes on and on and on. Here is what I have attempted so far. on the E682 I have tried both IP addresses (198.162.1.206 and 169.254.74.73) problem persists with either. I have tried 3 or different ethernet cables cat5e-cat7 including a brand new one. Problem persists. On the FPP side I have set up both a static IP for Eth0 (169.254.74.01) and Wlan0 (192.168.1.207) and I have checked the enable routing box cannot connect to E682. I have attached my network settings for the FPP and the E682 to this message and would appreciate any help or insight.
-Joey
The E682 and and FPP should both be connected to the router, not to each other. They'll talk to each other through the router as well as your computer will talk to each of them through it as well.
Without the router its like trying to send a letter down the street and expecting it to find its own way there without the post office.
The IP address of 198.162.1.206 is the default static address the E682 is shipped with. This is fine if the router is using the same IP range IE 198.168.1.xxx)
The IP address of 169.254.74.73 indicates an valid IP address could not be obtained (its looking for the router to assign an address but one it's being given) This should not be used when assigned static ip addresses.
Most common schemes to go with is 192.168.1.xxx or 10.0.10.xxx.
You should connect everything to the router, check the IP addresses the router is assigning to determine what address you should set the E682. For instance mine are set to 10.0.10.101 for my first E682 and 10.0.10.201 for my second (just for my memory's sake) and my FPP has an address of 10.0.10.102. I prefer to set my controllers and FPP with a static IP so I know they won't get changed by the router in the event of a power failure, etc. My router then is setup to assign addresses ranging from 10.0.10.2 (the router's address being 10.0.10.1) to 10.0.10.100 (I use 10.0.10.101 and above to manually assign static IPs to controllers etc.)
Codec101 you area life saver that did the trick! I feel like a heel I knew that about networking I just thought I saw to connect the R Pi to wifi and then R Pi to the controller from ethernet. Well now I just gotta fix my sequences (set up controller wrong) and test my LEDs to see if and where I need to power inject! Hopefully up[ and running tonight if not then tomorrow for sure!!



