e682 Config Page
 
Notifications
Clear all

e682 Config Page

31 Posts
11 Users
0 Reactions
8,653 Views
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago
[#40131]

There has to be elves in my e682 board...I have been in contact with Jim at Sandevices...he states my board is working correctly.

I have read the manual too many times... I can not connect the e682 to the config page.
My router IP is 192.168.1.92. Which is in the range of the the boards IP address 192.168.1.205

I have tried the Forced IP address - Program button and 6 flashes of the lights on the board - which forces the board to the factory set IP address 192.168.1.205
Still no connection.

Here is an error message I get when running diagnostics.

6

I have the board plugged into the router.... there is a green and yellow light on the boards CAT5 jack. Have tried it on both my MAC and an Windows PC.

They are both hard wired to the router.

I would really appreciate any help... we would love to get the matrix running by New Years since we won't make it for Christmas.

Thanks

Covewi


30 Replies
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

computers on the same subnet mask as the E682?


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Yes - do an 'ipconfig /all' on the PC from a CMD window and capture the IP settings of your computer and put that here. Can you ping the controller from the CMD window? Is it possible you have some virus software blocking access to the controller - seems unlikely since it happens to both your PC and MAC.


Reply
Lionking_Tx
Posts: 780
(@lionking-tx)
Prominent Member
Joined: 15 years ago

Do you know the FW of your E682 board ?
The instruction for V4 Firmware I have states that over ride code 6 sets the IP to 192.168.1.206 not 205.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago
budude wrote:Yes - do an 'ipconfig /all' on the PC from a CMD window and capture the IP settings of your computer and put that here. Can you ping the controller from the CMD window? Is it possible you have some virus software blocking access to the controller - seems unlikely since it happens to both your PC and MAC.

^^^ This


Reply
Page 1 / 7
Share: