Notifications
Clear all

E682 Backwards

5 Posts
5 Users
0 Reactions
1,428 Views
Posts: 373
Topic starter
(@blantrip)
Reputable Member
Joined: 16 years ago
[#55259]

I have two eE682’s running my mega tree.

Placing both the E682’s in RGB chase test mode, half of the mega tree looks like the lights are chasing up and the other half look like they are chasing down.

Selecting the 2nd E682 and selecting them to reverse in the E682 config screen they still chase down.

Sending effects to the tree from xlights the effect doesn’t look correct since half of the tree seems to be reversed.

I’ve compared every setting between the two controllers and they are both running the latest firmware.

I’m out of ideas, anyone know what silly thing I’ve overlooked?

Thanks in advance


4 Replies
Posts: 376
(@k-state-fan)
Reputable Member
Joined: 16 years ago

Some screenshots of your settings might help.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

After selecting reverse ,did you select save ?

How are your pixels wired ? Singular strings/strips ? Zig Zag strings/strips ?

Need more info to be of any help.


Reply
Posts: 459
(@shockwave)
Reputable Member
Joined: 15 years ago

If the pattern you are outputting is from GLEDIATOR or jinx! -- the patterns are stored top to bottom. Most of us start the tree lights from the bottom and go up. Thus, upside down.


Reply
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago

I would also suggest some screen shots. If you are using xLights, it is possible that the starting point (ex. bottom left) on one of the e682's may be wrong.


Reply
Share: