Notifications
Clear all

E681 Problem

20 Posts
10 Users
0 Reactions
7,225 Views
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago
[#20138]

I put together 2 E681 boards. The first one I built I have tested lots of GECE pixels with, it has worked perfectly. When I built the second one everything tested ok, the only pixel testing I did was using the 5 pixel WS2801 test pixels. I tested using the web interface and the pixels worked just fine. Today I was going to use the second board to test my GECE mega tree I was building. I couldnt get it to light any GE pixels. I verifyed I had changed the pixel type to GECE. After testing several things I noticed the fuse for the pixel was blown. I replaced the fuse and upon power up the fuse blew again.

I replaced the fuse and changed the config back to WS2801 hooked up my test pixels and they light up just fine. I thought maybe there was a load problem so I used just 4 GECE pixels. With only 4 GECE pixels hooked up the fuse does not blow but the pixels wont light. I put the thing up for the night and thought I would get some ideas on what to try next from the forums, I am out of ideas for right now. Any help would be great. Thanks.


19 Replies
Posts: 2171
(@mschell)
Noble Member
Joined: 18 years ago

Doug,
I think I saw a similar issue awhile back.

There's something about the loading of the pixels when the "type" of pixel is defined incorrectly on the E681.

I think I may have damaged one strip of TM1809 pixels when I connected it with the pixel type NOT set to 180x. However, it's been awhile and I'm not sure if that's the case.

However, just now, I did connect a WS2801 set to cluster 1, which was set to GECE. The first pixel glowed dimly, and I quickly shut it off. I disconnected the pixel string, and then reset the type to 2801. After powering on, the 2801 pixels worked fine.

I have had the fuse get blown in the past, but not tonight.

I would check all your connections, just to be sure there isn't a stray wire somewhere shorting out.


Reply
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago

The same pixels work on the other controller. I am sure I have configured the board correctly for each pixel type. The WS2801 pixels always work and the GECE pixels never work no matter what I have tried so far. I have tried different power supplys, powering from the board, powering externally. I am stumped.


Reply
chelmuth
Posts: 1077
(@chelmuth)
Noble Member
Joined: 16 years ago

can we get top and bottom photos of malfunctioning board. closer and clearer the better.


Reply
Posts: 1249
(@jstjohnz)
Noble Member
Joined: 17 years ago

I have never heard of a case where pixels were damaged by having the pixel type defined incorrectly, and I would be surprised if that would ever happen. The only two ways that I know of to kill pixels are by reversing power and ground, and connecting them to too high of a voltage.

Blowing the 5A fuse is indicating either a short circuit, voltage too high, or possibly reversed polarity.


Reply
Page 1 / 4
Share: