E6804 Resistor Netw...
 
Notifications
Clear all

E6804 Resistor Networks

12 Posts
7 Users
0 Reactions
4,508 Views
kidcole
Posts: 307
Topic starter
(@kidcole)
Reputable Member
Joined: 17 years ago
[#40977]

Is it possible to change the E6804 resistor networks using values similar to those on the E682 (33 ohms and up) ?

I've searched the forum trying to find information about changing the E6804 Resistor Networks (to support 50' cables), and didn't have any luck. They are not socketed on the E6804, and also located under the Ethernet card. So clearly no attempt to make this possible. But there appears to be enough room for a socket to be installed (barely).

Requirements: For the future, I'd like to see new Sandevices offerings with integrated uAmps... or at least a daughter port to add uAmps quickly to a controller.


11 Replies
kidcole
Posts: 307
Topic starter
(@kidcole)
Reputable Member
Joined: 17 years ago

Hmmmm can anyone help with this ?


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

The E6804 was designed to be low cost. For full functionality you'll have to step up to the E682. I'm sure you can put a second controller to use, or if not you can sell it for a good price.


Reply
Xenia
Posts: 1358
(@xenia)
Noble Member
Joined: 15 years ago

Kidcole, What Skunberg implied but did not directly say is that the E6804 does not have a resistor network that is there to protect the board from an output overload. The resistor networks that are there are part of the circuitry of the board and not part of the output circuitry. If you look at an E-682 you will see there are three resistor networks on the board in addition to the eight resistor networks protecting the outputs.


Reply
Posts: 366
(@technician)
Reputable Member
Joined: 12 years ago

If I understand correctly one has a true RS-485 driver chip for driving the outputs and has the resistors. The cheaper version does not nave the driver IC and directly drives the output from the micro controller output pins. Hope this helps. As such the current from the controller IC is LIMITED. and was never designed for driving a transmission line (network cable) directly. It does not meet RS-485 technical specifications.


Reply
Page 1 / 3
Share: