e1.31 bridge boot i...
 
Notifications
Clear all

e1.31 bridge boot issue

13 Posts
5 Users
0 Reactions
2,730 Views
Posts: 389
Topic starter
(@jcross)
Reputable Member
Joined: 15 years ago
iflights wrote:If you are willing, post a photo of the component and soldered sides and I'll be glad to compare visually against mine. Maybe a 2nd pair of eyes is all that is needed.

Sure can post these after work. I did do this with my working one already but as you said a 2nd pair of eyes never hurts... and I’m completely stumped.

Sent from my iPhone using Tapatalk


Reply
Posts: 250
(@outbreak)
Reputable Member
Joined: 12 years ago

Do you have the other E1.31 connected to your switch when you connect this one?


Reply
Posts: 389
Topic starter
(@jcross)
Reputable Member
Joined: 15 years ago
outbreak wrote:Do you have the other E1.31 connected to your switch when you connect this one?

Nope. I did plug it into the switch once to see what would happen and no ethernet lights came on the switch or the wiznet. With the wiznet module plugged in the bridge won't even boot up so it's not even at a point that an ip conflict could cause an issue.


Reply
Posts: 389
Topic starter
(@jcross)
Reputable Member
Joined: 15 years ago
iflights wrote:If you are willing, post a photo of the component and soldered sides and I'll be glad to compare visually against mine. Maybe a 2nd pair of eyes is all that is needed.

Sent from my iPhone using Tapatalk


Reply
Posts: 503
(@iflights)
Honorable Member
Joined: 14 years ago

Stare and compare complete. Looks great. I found nothing to call out.

Perhaps this...perform a Hard Reset and see if the Act led responds to that. If not, I'd be swapping out the CPU with another known working one. Can't think of another option.


Reply
Page 2 / 3
Share: