e1.31 bridge boot i...
 
Notifications
Clear all

e1.31 bridge boot issue

13 Posts
5 Users
0 Reactions
2,725 Views
Posts: 389
Topic starter
(@jcross)
Reputable Member
Joined: 15 years ago
[#49783]

Just wondering if anyone has any suggestions for next troubleshooting steps for a e1.31 bridge issue:

When powered up only the power led comes on. When I remove the wiznet ethernet module and power it up the act/status leds flash as expected... Put the wiznet module back in and power up no activity from act/status leds.

-I just soldered this board together, have reflowed and verified solder connections are okay and no solder bridges
-Power supply is a regulated 5v and power supply jumper is set to external
-I tried a wiznet module from another known working e1.31 bridge with the same result
-reprogrammed the prop chip with current firmware
-removed the mac chip in case it had issues

Even after all this it still will not startup with the wiznet module installed.
I searched the forums and wen't through all the suggestions for similar issues although didn't see any with this exact issue.

All suggestions welcome!

Thanks


12 Replies
Posts: 317
(@dvc2013)
Reputable Member
Joined: 14 years ago

Make sure you have the Wiznet module oriented correctly. This is exactly what happened to me when I put it in backwards.

The RJ45 should face the Propller chip not the outside of the board.


Reply
DrNeutron
Posts: 2016
(@drneutron)
Noble Member
Joined: 14 years ago

Yep this bit me in the ass when I put my 1st one together as well.
You would expect the RJ45 to face away from the board but it should face into the board.


Reply
Posts: 389
Topic starter
(@jcross)
Reputable Member
Joined: 15 years ago

absolutely!

I had installed it in the correct orientation from the get go.


Reply
Posts: 503
(@iflights)
Honorable Member
Joined: 14 years ago

If you are willing, post a photo of the component and soldered sides and I'll be glad to compare visually against mine. Maybe a 2nd pair of eyes is all that is needed.


Reply
Page 1 / 3
Share: