travisb6989 wrote:49 pixels per row. and nodes from holiday coro
I am running a 34 x 30 pixel matrix off of 6 outputs of an e682 this year. I understand the one row per output for simplicity, but that is going to be alot of wires going up the side of the matrix, not to mention alot of extra cost.
jaysdisaster wrote:No it will work with 5v or 12v
from the original uAmp post
" The uAmp operates as a 'pass through' for whatever voltage is supplied and would have the same 5-16V operating range "
Cool. I was mistaken from the 5v in the manual for the uamp. Didn't realize the data lines carry 5v which is what it was referring to.
I however cant seem to find the group buy for this nor a way to purchase on Falcon website.
Also is the uamp device designed to work from controller to first pixel or can it also work between pixels? Like in my part 2 of the question above.
travisb6989 wrote:i had planned on testing. Was just looking for a good rule of thumb to gauge my results on
My lights are all holiday coro. The service has been great and I have had good luck with the product so far. I am using 12v pixnodes and strips.
Sent from my iPhone using Tapatalk
Here is the group buy
http://falconchristmas.com/forum/index.php/topic,5129.msg53673.html#msg53673
my understanding and I am not an expert is they amplify the data signal and clean it up removing the ringing. So it can be used wherever you need it or daisy chained for a longer distance.
just a heads up the green site had a similar group buy for a buffer that was only 1.50 but it ended in the middle of February.
travisb6989 wrote: I however cant seem to find the group buy for this nor a way to purchase on Falcon website.
go to the falcon site and look under the 'vendors/other' section
go to the falcon site and look under the 'vendors/other' section[/Q
Found it thanks
