Display locks up
 
Notifications
Clear all

Display locks up

3 Posts
2 Users
0 Reactions
1,488 Views
JP90
Posts: 376
 JP90
Topic starter
(@jp90)
Reputable Member
Joined: 19 years ago
[#34698]

My problem is that my display will pause every now and then for about 1 second. I am using all SanDevices controllers and one Renard controller and a Netgear router out in the yard on which I turned the transmitter off, the all the SanDevices are tied to the router and my computer's ethernet runs to the router. My computer is an ACER i5 with 10GB of ram CPU is running at only 12%, free memory is 6GB network utilization is at 2.5% when the show is running, so it seams that this is not a lack of resources. First off I don't think it has anything to do with Vixen 3 because the preview does not pause and the sequences stay in sync. When the display stops the Renard devices also pause. I noticed that the data light on on the ethernet module on all the controllers will stop flashing at the same time the lights stop, also the data lights on my Netgear router will stop at the same time This also happened during a test in the house with only a 6 foot ethernet cable. I am running the Netgear with a fixed IP (dhcp is off) my computer's ethernet port is using a fixed IP also, I am running all my boards in Multicast mode. The display runs great except for the little pausing problem. I thing that the handshaking between my computer and Netgear router is causing the problem. The router is set at it's default settings except as noted above. I don't have a good grasp on the etrhernet part of this as I do for the rest of the setup. If any one might know where to start on this would be a great help. Thanks

PS I cleared all the logs and there are no errors listed in the Vixen log files. I am running V3.1u2

Gary


2 Replies
Posts: 295
(@daytimer)
Reputable Member
Joined: 15 years ago

Is the computer plugged into one of the switch ports on the router, or the WAN port? Make sure it's in one of the numbered switch ports. Also, try disabling the preview. Your machine has plenty of breathing room for memory and cpu, but it's something to try...
Do you have any power saving features enabled on your computer? Screen savers, turn off monitor, etc... Make sure none of that stuff is enabled.
You might also want to try posting this in the Vixen 3 forum. It could be a simple setup issue too...


Reply
JP90
Posts: 376
 JP90
Topic starter
(@jp90)
Reputable Member
Joined: 19 years ago

The computer is in a switch port, thre are no power save modes turned on, no screen saver, no drive shut downs enabled and no virus software installed (I don't use computer on line). Like I said I think it is something to do with the communication between the computer and router, I tried to replace the router with a hub just to test it and still had the same problem.


Reply
Share: