Different pixel str...
 
Notifications
Clear all

Different pixel strings in same E682 cluster?

6 Posts
4 Users
0 Reactions
2,123 Views
Posts: 654
Topic starter
(@szaske)
Noble Member
Joined: 14 years ago
[#24351]

Will it work if I connect say a 2811-based Pixel strip into the E682's cluster 1 socket 1 and at the same time connect a 2811 pixel string into cluster 1 socket 2? I'm trying to figure out how many controllers I need and what sort of pixels I need to buy. I'm thinking I'd like to standardize on the 2811...but those 3001's are mighty impressive. I just don't think I've seen a LED strip based on the 3001's.

-=Steve


5 Replies
Posts: 53
(@shubb)
Trusted Member
Joined: 14 years ago

You can have the same chip type in the cluster, but they have to be the same pixel length.
You can use a different chip type in a different cluster, or use a different length in a different cluster.
Hope that makes sense.


Reply
Posts: 654
Topic starter
(@szaske)
Noble Member
Joined: 14 years ago

Thanks for the response. That is what I thought. Couldn't I set the pixel length to whatever string was the longest (150) and then everything would work? I might have a bunch of ghost DMX channels wasted (not really pixels), but I think ever pixel would be controllable in this example.


Reply
Posts: 1249
(@jstjohnz)
Noble Member
Joined: 17 years ago

Remember the voltage has to be the same (obviously), but yes you can mix/match strings and strips. Yes you would use the length of the longest string in the setup.


Reply
Posts: 53
(@shubb)
Trusted Member
Joined: 14 years ago

If you had 1 string of 25 pixels and one of 50 pixels then you could set string to 2 and pixel to 50. The longer string would have to be in socket 1 and the shorter on socket 2. It would just ignore the extra channels on the shorter string.
I think that is what you were refering to.


Reply
Page 1 / 2
Share: