Dense E1.31 Pixel C...
 
Notifications
Clear all

Dense E1.31 Pixel Controllers

10 Posts
6 Users
0 Reactions
3,715 Views
Posts: 25
Topic starter
(@najetset)
Eminent Member
Joined: 8 years ago
[#50445]

I've been researching pixel controllers recently, specifically those with the densest pixel/channel output. So far I've found that the Falcon F16v3 and the Advatek PixLit16MkII seem to advertise the densest channel capacity for a single controller. With the Falcon showing 32,768 channels @ 40fps and 49,152 channels @ 20fps. The Advatek shows 49,152 - for now I'll just assume it too is at 20fps.

My question for the community is this: Are there any other controllers or control options that have a greater channel output? I have a particular "prop" that will have about 110,592 3 channel pixels so that, by my calculations, would require about 11 F16v3's @ 40fps, or similar controller.

I should add that I'm looking for something with an E1.31 input and at least a WS2811/12/12b output.


9 Replies
Posts: 1744
(@tjetzer)
Noble Member
Joined: 18 years ago

As far as I am aware those would be the highest output controllers available. Of those two I'd opt for the Falcon controller.


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago

I don't think you'll find anything more here. You are talking industrial strength stuff. Assuming 12 volt pixels, you are going to need over 600 amps at 120 volts. That's more than three residences worth. You'll have a bigger issue with power supplies and cabling. If you are doing a pixel matrix using matrix panels, you should look at Colorlight or Lynsn cards for control.


Reply
Posts: 25
Topic starter
(@najetset)
Eminent Member
Joined: 8 years ago
tjetzer wrote:As far as I am aware those would be the highest output controllers available. Of those two I'd opt for the Falcon controller.

Yes I too would lean toward the Falcon, all else being equal I do like the fact that it can act as a remote, offloading a lot from the master. But that said, I do like the idea of the 'expanded mode' of the Advatek, which doubles the output count, but halves the channels/output - which to me seems like it may be able to perform better (read:higher fps) than the Falcon. I'm waiting to hear back from Advatek on their expected frame rates in expanded mode.


Reply
Posts: 25
Topic starter
(@najetset)
Eminent Member
Joined: 8 years ago
ezellner wrote:I don't think you'll find anything more here. You are talking industrial strength stuff. Assuming 12 volt pixels, you are going to need over 600 amps at 120 volts. That's more than three residences worth. You'll have a bigger issue with power supplies and cabling. If you are doing a pixel matrix using matrix panels, you should look at Colorlight or Lynsn cards for control.

Power is of no issue for what/where I'm planning the display. I will research your control suggestions though, thanks!


Reply
Page 1 / 2
Share: