Hi all,
I'm making good progress on building controllers and getting everything setup. However, I think I am wasting a LOT of money on extra PSU's and demarcation boxes and such, and want to get some suggestions on what I'm thinking "might" work?
Questions throughout:
Current setup
- One main F16v3 at the mega tree powering 16 strings of 66 2811 pixels each (this currently only has one 12V 300W PSU, but I am guessing once i power it all up, i will quickly realize i need to split this to 2?). This is all mounted in a CG-1500
- Differential Expansion board (via ribbon cable) is mounted in the same box
- 2 additional CG-1500 boxes with 1 12V 300W PSU in each plus one differential receiver board in each. 1 in the yard, and one in the attic.
I have 2 additional differential receivers needed for the show, but location-wise... they would need to be about 40-50 feet away from each of the other boxes.
Instead of continuing to have a PSU per 4 string differential receiver... can i use 12/2 Landscaping wire (or similar) to run a power line from the PSU to a smaller box containing just the differential receiver in it? Then I would use 18/3 to distribute from there to each pixel string (max 10-15 feet each)?
Thanks for any thoughts you guys have on this? I suppose the other option is to keep the differential receivers close to the PSU, and then use 16/3 or something more substantial to run longer lengths to each pixel string? Not sure if one way is better than the other???
Here is a pic of one of the smaller boxes and a small test I'm trying to do. Where the red/black wires come out of the box is what I'm thinking of replacing w landscape wire for a long run. 
Sent from my SM-G955U using Tapatalk
I use a lot of landscape wire. There are over 2000' of it in my yard to support various props. I tend to use the 12 AWG and 14 AWG versions.
If you run your tree in the 30% range, you *may* be able to get away with a single PSU.
From a voltage standpoint, you’ll lose a little bit less than one volt over 50 feet with a 5A load on 12AWG wire (if my calculator is correct), so it’s probably feasible. Make sure to keep track of which wire is ground and V+.
I am curious what box you are using in your pic. I was looking to house a power supply and differential receiver also, without too much wasted space. That one looks like it would fit the bill.
