Controller Network ...
 
Notifications
Clear all

Controller Network Connection

10 Posts
5 Users
0 Reactions
2,515 Views
Posts: 11
Topic starter
(@0207whodat)
Active Member
Joined: 7 years ago

I get full WiFi signal well past the distance of where I want to do the display

Sent from my iPhone using Tapatalk


Reply
Posts: 376
(@k-state-fan)
Reputable Member
Joined: 16 years ago

Add a pi with FPP


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

There's several things here we're reading "between the lines". So be patient with us as we're working with assumptions. But know that many of us have been doing this for a long time and know all too well the situation you're putting before yourself. You have a 682, so you'll probably be wanting to send a dozen universes of data to it. But if you want to do WiFi, you need to use it in multicast mode which will limit you to 6 universes. You've said that you're getting "full wifi strength well past the display" which is 100' from your previous post. Unless you have an site engineered outdoor setup, that's not even realistic. Your phone very well might report "3 bars of signal" and be able to get to the internet fine from that distance. But you very likely do not have good signal strength at that distance. Most probably not good enough for a nonstop stream of universe data. And you can't be using that same wifi network for this application anyhow.

Streaming ACN is a very different beast from your typical network traffic. You don't want to put it on your household wifi. Any other trafic beyond the lighting data will cause the performance of the lighting equipment to suffer dramatically. Just look at the multitude of current threads with all of the people struggling to get it working well. In addition to those challenges, you'd have additional challenges because the 682 controller doesn't do IGMP, which will make multicast difficult to achieve. You'll need to force it thru the wifi link. That's not going to be an easy hurdle to overcome.

As someone above pointed out, you could use a pair of ubiquiti APs (or similar) to make a point to point wireless network bridge. But this is also an advanced topic and will require a good deal of knowhow to accomplish.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Putting the PI colocated with the controller is one of the better ideas here. That way the only traffic on the WiFi is the FPP sync traffic which is very light. The PI local to the controller sends the data to the controller over the local wire so non of it leaks to the WiFi.


Reply
Posts: 11
Topic starter
(@0207whodat)
Active Member
Joined: 7 years ago
K-State Fan wrote:Add a pi with FPP

I have a Pi4 (still in box). So I would put sequence on micro sd and connect pi to controller? No connection is required between pi and router?

I really appreciate everyone’s help and advice!

Sent from my iPhone using Tapatalk


Reply
Page 2 / 2
Share: