Controller Network ...
 
Notifications
Clear all

Controller Network Connection

10 Posts
5 Users
0 Reactions
2,514 Views
Posts: 11
Topic starter
(@0207whodat)
Active Member
Joined: 7 years ago
[#51977]

Plan to build a display approximately 100 feet from the router in my house. I know this is probably a dumb question, but there must be a way to connect the controller to the network without running 100 feet of Cat 5 cable, right? San Devices E6804 controller

Sent from my iPad using Tapatalk


9 Replies
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Just run the cable. it's far easier than the alternatives.


Reply
Posts: 11
Topic starter
(@0207whodat)
Active Member
Joined: 7 years ago

100ft is a straight line. It would take a few hundred feet of Cat 5 cable.

Sent from my iPad using Tapatalk


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Ethernet is good for cables up to 100m long.
Alternately you can get a pi and install FPP in slave mode. Connect the pi to the 682 via Ethernet and send the multisync to the FPP via WiFi. That of course assumes you’re using a master FPP to run the show in the first place. But if you’re going to do this you might as well have gotten one of the pb based pixel controllers instead of the 682.
What you don’t want to do is try to use a cheap WiFi bridge to make the 682 wireless.

Sent from my iPhone using Tapatalk


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

Hard to beat the price and simplicity of 100ft of cat5! I ran that way for many years...
You could use a pair of Ubiquiti NanoStationM2 as a wifi bridge, or you could use one NanoStationM2 as a "station" listening to your wifi access point in the house. Wifi comes with a host of setup issues.


Reply
Page 1 / 2
Share: