Controller Firmware...
 
Notifications
Clear all

Controller Firmware Limitations

21 Posts
5 Users
1 Reactions
3,154 Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago

Which 'transmitter' are you using to output to the pixels? SPI, RMT or ???


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

For ESP8266 I am using the UART
For ESP32 I use the RMT devices


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago

Thanks. I'm not sure how much further I'm going to go with the ESP32. The small physical size of the ESP01 is more to my liking, since I don't have much interest in high pixel-density props.


Reply
dirknerkle
Posts: 10309
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

We almost always acquire the mindset that "more is better" -- for some reason we equate the concept of bigger size to better quality. It's not always the case. One can do a LOT with only 150-250 pixels and create a wonderfully effective display piece. Another benefit of designing a show using smaller counts of lights is that if the section goes out, it doesn't usually kill the whole display, only a part of it. DIY'ers who have encountered a major show failure when their main controller goes out are quite familiar with the issue of relying on a single piece of gear for their whole show. When you put all your eggs in one basket, you better keep a backup basket in the closet!


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago

It all depends. If you want to include props with high pixel counts, such as mega-trees or big panels, then big controllers are called for to drive those elements. But small controllers might be a better choice for other props.


Reply
Page 2 / 5
Share: