Notifications
Clear all

Color values

5 Posts
4 Users
0 Reactions
1,519 Views
Posts: 5
Topic starter
(@newton82)
Active Member
Joined: 9 years ago
[#54685]

What are the best color values to use for colors like orange and purple? Thank you in advance


4 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Orange is supposed to be #FFA500 (255,165,0). Some like it a bit darker so try #FF8C00 (255,140,0). Still others like "orange red" at #FF4500 (255,69,0).
Note that these are from my color chart (and also found on Google). Pixels vary and some of the numbers will need to be adjusted to your liking in your circumstances.

FYI - These are Hex codes followed by R, G, B.

Another thing to remember is a LOT of us don't use our pixels above 30%. Most of my controllers are capped at 25% (where possible). When the brightness level is turned down, the color mix changes as well. Play around and see what colors you like, using your pixels, at your brightness level. You might just be surprised how good it all looks when you aren't being blinded!


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago
algerdes wrote:Another thing to remember is a LOT of us don't use our pixels above 30%. Most of my controllers are capped at 25% (where possible). When the brightness level is turned down, the color mix changes as well. Play around and see what colors you like, using your pixels, at your brightness level. You might just be surprised how good it all looks when you aren't being blinded!

This has the effect that fades aren't going to work well with these mixed colors.

Just to see how well it would work, I'm working on a custom pixel that has 16,384 intensity levels/primary color (14 bits). They would be quite expensive (perhaps $1.50/pixel), so I would only assemble a small number of them for special purposes (inside pumpkins, etc), rather than huge numbers strung across the stage. Without going into details, it would take some tricks to access the addition bits/pixel. Right now I'm waiting for boards, and it may be a while before I get back to these.

Not having looked into it, I'm also under the impression that 12-bit pixels are available.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
P. Short wrote:This has the effect that fades aren't going to work well with these mixed colors.

Just to see how well it would work, I'm working on a custom pixel that has 16,384 intensity levels/primary color (14 bits). They would be quite expensive (perhaps $1.50/pixel), so I would only assemble a small number of them for special purposes (inside pumpkins, etc), rather than huge numbers strung across the stage. Without going into details, it would take some tricks to access the addition bits/pixel. Right now I'm waiting for boards, and it may be a while before I get back to these.

Not having looked into it, I'm also under the impression that 12-bit pixels are available.

14 bit that sounds cool !
At some point over the past 4-6 months , I read a post about someone doing 16 bit code for pixels. I cannot recall if it was a reddit thread or a specific code on git .


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Wasn't there a 24 bit initiative in stage lighting awhile back? Can you imagine trying to satisfy some artistic director about what color something was supposed to be? Madness.


Reply
Share: