Cheap but dependabl...
 
Notifications
Clear all

Cheap but dependable

37 Posts
14 Users
0 Reactions
10.8 K Views
Posts: 210
(@gadgetsmith)
Estimable Member
Joined: 13 years ago

How about an NRF transceiver connected to the Pi for the transmitter, and a Komby RF1_12v for the receiver.

Just another thought.


Reply
Posts: 2
(@rayhaz)
New Member
Joined: 11 years ago

Howdy... new here to the forum, but tossing in my 2 cents.

I've been doing some "custom control" on various WS2811-based strips for almost 2 years now. My latest projects are using the Cypress "System on Chip" PSoC controllers. The nice part is that a 5LP (low power) mini-board is about $10 a Digikey, so if you want to do a lot of it, they're pretty cheap to use. http://www.digikey.com/product-detail/en/CY8CKIT-059/428-3390-ND/5184557

Of course the downside is What You See Is What You Get. I've soldered on some headers, wire-wrapped to a solder breadboard, and connected it all to a USB power stick, and run it for demo purposes. A demo of the stand-alone box should be available here later today:

.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

The E6804 in kit form is $69. I have 2 of them and also use one output to run Renards.

Sent from my Nexus 7 using Tapatalk


Reply
Posts: 98
Topic starter
(@ronaldpa2)
Estimable Member
Joined: 12 years ago

So I got the easypix from holiday coro but i am having issues getting it to drive robs leds floods. Anyone use the easypix successfully with robs setup?


Reply
Posts: 1344
(@mrsmoofy)
Noble Member
Joined: 12 years ago
ronaldpa2 wrote:So I got the easypix from holiday coro but i am having issues getting it to drive robs leds floods. Anyone use the easypix successfully with robs setup?

I've not tried it myself I have everything to put it together to test other then time 🙂 Can you describe how you have it all wired up pictures would be good too. I'll try to get one assembled this weekend and give it a try to see what luck I have.


Reply
Page 6 / 8
Share: