Another ESPixelstic...
 
Notifications
Clear all

Another ESPixelstick IP Question

4 Posts
3 Users
0 Reactions
1,372 Views
Posts: 304
Topic starter
(@dennis-cherry)
Reputable Member
Joined: 19 years ago
[#50287]

Can you have two ESPixelsticks on the same IP address?

If so how do you set them up? one will work and the other will not, depends on which one the router sees first.

I want to setup 2 props on Universe 1 with one prop using pixel 1-50 (1-150) and the other starting at pixels 51-150 (151-450).

Can that be done?


3 Replies
Posts: 191
(@davemck)
Estimable Member
Joined: 10 years ago
Dennis Cherry wrote:Can you have two ESPixelsticks on the same IP address?

If so how do you set them up? one will work and the other will not, depends on which one the router sees first.

I want to setup 2 props on Universe 1 with one prop using pixel 1-50 (1-150) and the other starting at pixels 51-150 (151-450).

Can that be done?

You don't need or want the two devices on the same IP address. Set up both to use multicast, and tell both to use the same universe number, but adjust the starting channel number. In your show software add a multicast controller with however many universes you need. When a sequence runs it will send out one 'blanket' message and the ESPs will pull out the universe(s) and channels they are listening for.

Sent from my Moto Z (2) using Tapatalk


Reply
Posts: 360
(@jlstout)
Reputable Member
Joined: 16 years ago

Set them up multicast dhcp. Your router should not be assigning the same ip address.


Reply
Posts: 304
Topic starter
(@dennis-cherry)
Reputable Member
Joined: 19 years ago

OK, thought that was the way to go.

Will change one of the IP's to another static address and leave the other setting alone. Do not use DHCP, but do use a couple of reserved IP's for my PCD and computer.

DaveMcK wrote:You don't need or want the two devices on the same IP address. Set up both to use multicast, and tell both to use the same universe number, but adjust the starting channel number. In your show software add a multicast controller with however many universes you need. When a sequence runs it will send out one 'blanket' message and the ESPs will pull out the universe(s) and channels they are listening for.

Sent from my Moto Z (2) using Tapatalk


Reply
Share: