Hi guys,
yesterday I was made small PCB designed for ESP8266 E12 module. This board can supply 5/12V. 74hc245 used for DATa out (because I had a lot IC's in my box).
At now I wait for PCB's for prototypes. When everything will work prop - I will put for free download.
Tested with great ESPixelStick firmware by forkineye - thank you Shelby !!!
https://github.com/forkineye/ESPixelStick
Here is Eagle's screenshot of my PCB
I use (most) WS2812b/WS2811/UCS1903 IC's, so CLK signal is not connected to terminal block - is pad only for wire soldering if needed.
This is my first Eagle project 🙂
Interested in seeing the final product.
Following ! 🙂
Love this one Kris !!
Nice work on the PCB too
🙂
Did you use an ESP8266-12 so you could mount it smd?
I would like to see the schematic. Interested in how the software gets updated after the module is soldered down.
I wonder if you will have any range problems or signals issues with a ground plane and other traces under the antenna.
