Hello,
For a few day searching over the internet and trying to find a solution but without succes. So i hope you guys can help me:
i have to alphapix 16 controllers I control these boards with Xlichts.
So i have 16 universe one 1 board. Every universe control max 111 pixels (so that give me 333 chanels)
according to the manual there are 340 [channels] pixelse available per universe. So this looks OK by mee.
But after channel 7 there is an disturbance and the channels 8 and higher react slower than the first 7 chanels.
the settings in xlights see pictures.
I hope any one can give me a hand whit this issue. Thx.
----------------------------------------------
Change 340 channels -> 340 pixels
Actually 170 pixels is a full universe, a universe it 510 channels.
For DMX lighting this you are right.
but this is on the site of holliday coro:
Hardware Data Outputs
16 SPI (pixel) Outputs
Overall - Maximum of 5,440 Pixels or 32 Universes / 16,384 DMX Channels
Per Output - Up to 340 pixels / 2 DMX universes (exclusive of power, see chart below)
It seem to be a problem in Xlights.
i tested the controlloer whit Jinx! en ther is no disturbance at all....
Any idee what settings are wrong in xlights?
I was not aware you were talking about max output per port, however in E1.31 510 is a universe size. DMX actually uses 512. In xlights, you set your universe size to 340 but did you set up the controller UI for each port
MikeKrebs wrote:I do not know the algorithm in the Alphapix but I set the channels in xLights to match the channels in my alphapix and those are both divisable by 3. 340 channels should be something else by that logic.?
Ok i did a test, Restore factory settings, each univers ( 1/3/5/7 ... 31) 340.
In Xlicht i add 1 controller whit 32 universe and every channel 340 channels.
still the same problem...
I also tested it in vixen en there is no disturbance.
MartijnDamen wrote:Ok i did a test, Restore factory settings, each univers ( 1/3/5/7 ... 31) 340.
In Xlicht i add 1 controller whit 32 universe and every channel 340 channels.still the same problem...
I also tested it in vixen en there is no disturbance.
You need to go to the Pixel Output configuration page and input how may pixels off each port and what universe each port is, the controller must know exactly how many pixels is being run off each port, please post a picture of the configuration page showing the outputs.
Hi dim bulb, in my opening post are 2 attachements.
The first are the controller settings
The second is one star element.
On the controller i set Every universe/output gate 340 channels.
Van you Find Any wrong setting?
MartijnDamen wrote:Hi dim bulb, in my opening post are 2 attachements.
The first are the controller settings
The second is one star element.
On the controller i set Every universe/output gate 340 channels.Van you Find Any wrong setting?
On the controller, for port 1, you need to set the amount if pixels, nit channels, in this case, port 1 is the star, the star is 65 pixels.
I made the following settings, see attachments:
universe 1 to 11 an 15 and 16 is set to 1 pixel
Universe 12/13/14 is set to 65 pixels
but stil issues.
In vixen and Jinx works fine, no disturbance....
Is ther a way to convert xllights to vixen?
I spend a mucht time building my show, and did not expect this.....





