2 Alphapix 16 contr...
 
Notifications
Clear all

2 Alphapix 16 controllers help

6 Posts
2 Users
0 Reactions
5,365 Views
Posts: 42
Topic starter
(@heffyone)
Trusted Member
Joined: 16 years ago
[#46625]

Hello all....I am new to the pixel world and have had many questions answered by reading a lot, but I have one huge question...
First I have 2 Alphapix 16 controllers that I am going to use in my display. I am using an Ethernet switch to connect them both to my computer, however when I connect them to the switch only 1 of the controllers is showing up in my network.
I don’t know if this matters but I already have them assigned different IP addresses.

If anyone can help me out I would greatly appreciate it. I have most of the steps from there mapped out (assigning universes, pixels, channels, etc) but I need to figure out how to get both controllers to show up.

If this info is needed I am using both of these Alphapix controllers to run 1 - 360 degree mega tree and am trying to make it as easy as possible.

Thanks in advance for any help!


5 Replies
StickyWicket
Posts: 548
(@stickywicket)
Honorable Member
Joined: 14 years ago

What IP address did you give each controller? Did you verify the IP’s are reported correctly on the controller screen?


Reply
Posts: 42
Topic starter
(@heffyone)
Trusted Member
Joined: 16 years ago

The 1st controller IP address is 192.168.0.50 (this was set by the retailer when i received it) the 2nd controller IP address is 192.168.0.52 (I set this one because when I received both controllers they had the same IP addresses).
The IP addresses do show up, as they are noted above, on each controllers screen.
Thank you!!!


Reply
StickyWicket
Posts: 548
(@stickywicket)
Honorable Member
Joined: 14 years ago

Have you looked at the attached devices screen on your router?


Reply
Posts: 42
Topic starter
(@heffyone)
Trusted Member
Joined: 16 years ago

I have not but will when I get home in the morning (I work night shift)


Reply
Page 1 / 2
Share: