12 volt pixel issue
 
Notifications
Clear all

12 volt pixel issue

7 Posts
3 Users
0 Reactions
2,628 Views
Posts: 5
Topic starter
(@msuirocks)
Active Member
Joined: 6 years ago
[#54315]

I am hoping someone has seen this problem before. I bought some new strings of 12 volt WS2811 100 node pixels. 5 strings, so 500 pixels. My problem is when I hook them up to my F16V3 falcon controller, the first 8 pixels come on by them selves. When I run a sequence all the other lights(92) work as they should. All 5 strings do this. I have never seen this, hoping that someone on here has.
Thanks


6 Replies
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

please post a picture of the port/string configuration page. Also put the f16 into test mode and tell us if you still see the issue.


Reply
Posts: 5
Topic starter
(@msuirocks)
Active Member
Joined: 6 years ago

I have put it in test mode, and the first 8 dont respond. The first 7 stay blue and the 8th one is green. i am posting pictures not in test mode and in test mode. I have another ws2811 50 pixel string hooked up and it works fine.

20210619 193615
20210619 193600
20210619 193600
20210619 193622
20210619 193622
20210619 193622
20210619 193622
20210619 193616
20210619 193615
20210619 193615

Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

if string 2 works then the config is ok. i would start removing one pixel at a time until you have a (shortened) string that works.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

This statement "I have another ws2811 50 pixel string hooked up and it works fine" indicates the issue is with the pixel string that is not working. However, is this "other" string hooked up to the same port that is having an issue? Making such a statement about a string on a different port is not useful and can be misleading. If you say that you have a string that works fine on port X and when you move it to port Y it stops working properly, that is a big piece of data. Have you tried the non working string on a known working port? Have you tried a known working string on the port that is having issues? This is data that is needed to debug such an issue. That or start cutting up your string and if the issue ove up the string then you know you have a problem port and if the working pixels continue to work then you know you have bad pixels. I would swap strings between ports first.

Martin


Reply
Page 1 / 2
Share: